MAMBA Basic F722 MK3 F50 BLHELI_S Flight Controller Stack

FIXED

• Add I2C function
• When you connect the USB, the receiver and OSD settings can be saved
• Increase the pad area
• LED signal selection （when Mamba Led sys avaiable）
• BEC short circuit protection
• TVS instant high voltage protection 30V

UPDATE

• Upgrade the anti-interference cable
• Use Typec（Most）
• The pad area of the Mini flight controller (20×20) increased by 140%

ADDED

• Add self-recovery insurance to the receiver's 5V power supply.
• Increase the camera VCC power supply pad.
• The standard flight controller (30.5×30.5) adds a spare pad.
• Gyro uses an independent Low Dropout Regulator (Low Dropout Regulator) and reduces ripple interference.
• Diagram Link From Help Centre Link

FC SPECIFICATIONS

• MAMBA Basic F722MK3
• MCU: 216MHz STM32F722RET6
• GYRO: MPU6000
• Barometer: Yes
• OSD: Yes
• Blackbox: 16M Flash Memory
• Uarts: 6Set
• ESC Soft: Dshot300/600
• ESC Telemetry: Yes
• Power Led: Yes
• LED Controller: BF LED/MB LED（4 Set 2812 LED）
• S/F.Port: Yes
• RSSI: Yes
• Buzz: Yes
• Input: 3~6S Lipo (12.6~25.2V)
• TVS Protection: Yes
• BEC:3.3V 0.5A& 5V 3A (System Power)&
• 5V 3A(LED)& 9V 3A
• MOUNTING: 30.5mm, M3

ESC SPECIFICATIONS

• MAMBA F50_BLS
• INPUT VOLTAGE: 3~6S Lipo (12.6V~25.2V)
• CONTINUE CURRENT:50A×4
• BURST CURRENT:60A (10S)
• BEC: No
• Target：BLHeli_S CH40
• SOFT: Dshot300/600
• TVS Protection: Yes
• MOUNTING: 30.5mm/M3

SUPPLY :

• High-Frequency 470uF/35V ×1
• 8pin sh1.0 ×2
• 12AWG 100mm ×2
• AMASS Original XT60