Flight Controller F411-WING

FC Specifications

• MCU: 100MHz STM32F411
• IMU: MPU6000 accelerometer/gyro (SPI)
• Baro: BMP280 (I2C)
• OSD: INAV OSD w/ AT7456E chip
• Blackbox: No
• VCP & 2x UARTs
• 2x Motors, 5x Servos outputs
• 1x I2C
• 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
• Built in inverter for SBUS input (UART1-RX)
• SoftSerial_Tx1: ST1 pad by default
• PPM: ST1 pad with softserial disabled
• Battery Voltage Sensor: 1:10 (Scale 1100)
• WS2812 Led Strip : Yes
• Beeper : Yes
• RSSI: No

FC Firmware

• INAV Flight
• Target: MATEKF411

PDB

• Input voltage range: 6.5~30V (2~6S LiPo) w/TVS protection
• 2x ESC power pads
• Current Senor: 78A,  3.3V ADC,  Scale 423

BEC 5V output

• Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed
• Continuous current: 2 Amps

BEC Vx output

• Designed for Servos
• Voltage adjustable, 5V Default, 6V via jumper
• Continuous current: 3 Amps

BEC 3.3V output

• Designed for Baro / Compass module/ OLED and Spektrum RX
• Linear Regulator
• Continuous current: 200mA

Physical

• Mounting: 24 x 24mm, Φ2mm
• Dimensions: 41 x 28 x 10mm
• Weight: 7g (Total 12g w/ bottom plate and M2 standoffs)